Giant Control Panels
Posted on Jun 22, 2023MAP produced these fascia control panels using 55 years of tried and tested methods. Although they were a little bigger than usual at 1800mm x 100mm, this posed no problem as we have the expertise and equipment ready to tackle jobs of this nature. We printed the job 9-up on our digital Swiss Q using ReflexTM 175-micron textured polyester material. All the colours are printed on the back to give extra protection to the print. This fascia control panel has an LCD window. To facilitate this we needed to turn the sheet over to print a UV varnish over the window area to create a clear window within the texture of the material. Then we created a 9-up, 3M 467 adhesive gasket which had been cut on the Zund G3 L-3200,that was applied using our Roll-X laminator to guarantee the exact position of the adhesive each time, around the LCD window and the rest of the panel. Finally, we went on to the final cut on the Zund G3 L-3200 which you are seeing on the video clip. There’s always a bit more in every standard job.